Is it possible to replace a small section of carpet




















When it comes to caring for your carpet, you can trust the experts at Carpet Call to help. Carpet Call takes the hassle out of new home furnishings by offering a free measure and shop at home service that brings our products right to your door.

Book Free Measure. The store will not work correctly in the case when cookies are disabled. Shop Carpet. Shop Hard Flooring.

For small sections, you can purchase a carpet repair tool which resembles a round cookie cutter with a sharp edge.

Press it over the damaged area and turn until you reach the padding, then pull out the circular piece and patch as you would a large section. Older carpet in high traffic areas might be more faded or worn than remnants or patches taken from hidden areas of the room. This might make larger patches noticeable. You can use carpet tape instead of adhesive for larger patches, but it is not ideal for small repairs. The tape becomes bunched or balled up when working with a small opening, rendering the tape useless.

Measure the carpet area in need of replacement. If using a carpet patch kit, the included tools make it easy to cut a precise size and shape out of both the existing carpet and the remnant piece. Skipping the patch kit? Simply tape off a square or rectangular section of the stained or damaged carpet.

Using the kit tools or a utility knife, carefully carve out the carpet section you wish to patch, then immediately proceed to prepare the replacement.

After measuring and double-checking your measurements, cut the carpet remnant to fit precisely within the now-empty area. For easier and more precise cutting , be sure to lay the patch face down and to cut along its underside. Apply the carpet patch adhesive directly to the empty space, followed by the patch itself. Tips and Warnings. Things You'll Need. Related Articles. Article Summary. Method 1.

Measure the damaged area of the carpeting. Use the tape measure to identify the size of the patch that will be extracted from the surrounding carpet. This will make it easier to cut a replacement patch to size. Tape off the area to be removed. Use duct tape to outline a square section to be removed. Check the position of the tape with the measurements taken previously to make sure the inside edge of the tape matches those dimensions.

Be sure that the place you farm the replacement carpet from isn't going to be visible. You can also keep extra carpet in your attic or storage for repairing damaged areas.

Remove the damaged section of carpeting. Use a utility knife or a carpet cutting tool to gently cut along the inside edge of the duct tape. Apply just enough pressure to cut through both the surface of the carpet and the backing, but not enough to damage the underlying layer of padding. Once the section is completely cut, lift it off the carpet surface. Once an imprint has been made, attach the cutter blades and the pivot screw and make your incision, rotating as many as two or three times in order to remove it.

Measure and cut the replacement patch. Turn a carpet remnant face down and measure a patch for the carpeting, using the measurements obtained earlier as a guideline. Mark the lines of the patch with the pencil, and then use a utility knife or carpet cutter to cut out the patch. Prepare the carpeting to receive the patch. Neutralize the disk temporarily by putting a small amount of water on it.

Lift the edges of the carpeting around the hole and slide the adhesive disk underneath, with the adhesive side facing upward. When the patch becomes sticky again, in about three to five minutes, press down on the outer edge of the carpet to secure it into place. Move the carpet patch into position. Groom away any loose carpet fibers from the edge of the hole. Check the fit before applying any glue.

Then, put down a thin layer of carpet glue along the edges of the adhesive disk. Place the patch into the hole, taking care to make sure the fit is snug and even. Press lightly to allow the backing on the patch to come into contact with the underlying tape and adhere properly. You have about 15 minutes to position and align the patch perfectly before the glue sets, permanently anchoring your patch in place.

Work quickly. Smooth the pile of the carpeting to hide the seams of the patch.



0コメント

  • 1000 / 1000